Overview - Coolant Pipes (Version 2)
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2017 Audi S5, 2016 Audi S5, 2016 Audi S4, 2015 Audi S5, and 2015 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Left Front Coolant Pipes
- Removing and installing. Refer to FRONT LEFT COOLANT PIPES, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Bracket
- Bolt
- 22 Nm
- Bolt
- 2.5 Nm
- Bolt
- 9 Nm
- Front Coolant Pipe
- Removing and installing. Refer to FRONT COOLANT PIPES, REMOVING AND INSTALLING .
- Seal
- Replace
- O-Rings
- Replace
- Engine Coolant Temperature Sensor -G62-
- Removing and installing. Refer to Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING .
- Bolt
- 5 Nm
- Lower Coolant Pipe on Supercharger
- Together with -19-, removing and installing. Refer to COMPRESSOR COOLANT PIPES, REMOVING AND INSTALLING .
- Bolt
- 5 Nm
- Alignment Sleeve
- Seal
- Replace
- Bolt
- 5 Nm
- Seal
- Replace
- Upper Coolant Pipe on Supercharger
- Together with -13-, removing and installing. Refer to COMPRESSOR COOLANT PIPES, REMOVING AND INSTALLING .
- Alignment Sleeve
- Bolt
- 5 Nm
- Seals
- Replace
- O-Ring
- Replace
- Upper Coolant Pipe
- Removing and installing. Refer to UPPER COOLANT PIPES, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Seal
- Replace
- Bolt
- 9 Nm
- Bolt
- 3 Nm +90° turn
- Replace
- Bolt
- 3 Nm +90° turn
- Replace
- Left Coolant Pipes
- Removing and installing. Refer to LEFT COOLANT PIPES, REMOVING AND INSTALLING .
- O-Ring
- Replace
- Clip
Charge Air Cooling Pump - V188-, Tightening Specifications
-- Tighten the nut -2- to 9 Nm.
Engine Temperature Control Sensor - G694- - Tightening Specification
-- Tighten the Engine Temperature Control Sensor -G694- -1- to 3 Nm.