LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 592 (Brake System - Mechanical Components (Sedan) (As Of 09.2011)) >> 46 Mechanical Components >> Removal And Installation >> Rear Brakes >> Rear Brake Shield >> Installing

Rear Brake Shield: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

-- Position the brake shield.

-- Install the bolts on the brake shield and tighten them.

-- Install the rear brake disc, refer to REAR BRAKE DISC .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure the brake hose is correctly installed and secured inside the bracket on the stub axle carrier. So that the brake hose does not come out of the bracket on its own.

-- Install wheels.

Wheel bolt tightening specifications, refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower vehicle.

scientia non olet · About LEMON Manuals