Front Brake Pads, FN-3: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

-- Raise the vehicle.

-- Remove the wheels.

NOTE:

When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!

-- Remove -13- caps.

Fig 1: Identifying Front Brake Components (FN-3)

Courtesy of AUDI OF AMERICA, LLC

-- For vehicles with the brake wear pad indicator, disconnect the left front connector -4-.

-- Lift securing strap slightly at bottom of connector and then rotate 90°.

-- Remove the lower part of the brake pad wear indicator connector from the bracket.

-- Using screwdriver, pry off brake pad retaining spring from brake caliper housing and remove.

Fig 2: Identifying Brake Pad Retaining Spring From Brake Caliper Housing

Courtesy of AUDI OF AMERICA, LLC

-- Loosen and remove both guide pins -12- from the brake caliper.

Fig 3: Identifying Caliper Guide Pins, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Secure the brake caliper to the vehicle with a suitable wire. Do not support the weight with the brake hose.

-- Remove brake pads from brake caliper housing or from brake carrier.

WARNING:

Do not press the brake pedal when the caliper is removed.