Brake Caliper With Front Brake Carrier, FN-3: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Always use new bolts .

-- Carefully press the brake caliper with the brake carrier and the brake pads installed over the brake disc.

-- Tighten the brake carrier with new bolts -5-.

Fig 1: Identifying Front Brake Components (FN-3)

Courtesy of AUDI OF AMERICA, LLC

-- Place the brake hose in the bracket.

-- Install wheels.

Wheel Bolts, Tightening Specifications, refer to WHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower vehicle.