Electro-Mechanical Parking Brake Control Module J540: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Connect the electrical connector -2- on the control module.
-- Slide the retainer on the connector back and lock it.
-- Insert the control module.
-- Install the nuts and tighten to 9 Nm.
Install the trailer mode control module and bracket, if applicable. Bracket, 3 Nm.
-- If the electronic parking brake control module is replaced, select the "Replace" function for the respective control module in "Guided Fault Finding".
Use the vehicle diagnostic tester.