Rear Brakes Guide Pins And Protective Caps: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Grease the guide pin before inserting.
-- Slide the protective cap over the groove on the guide pin.
-- Slide the guide pin -8- with the protective cap -9- through the brake carrier.
-- Press the protective cap over the groove on the brake carrier.
-- Insert the brake caliper.
-- Install the bolts -1- and tighten them.