Electronic Parking Brake Rear Caliper
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When servicing, install entire repair kit.
Apply thin coat of assembly paste G 052 150 A2 to brake cylinders, pistons and seals.
- 1 -
Self-Locking Bolt
- 35 Nm
- Always replace.
- Counterhold at the guide pin when loosening and tightening.
- 2 -
Brake Caliper Housing With Actuator
- 3 -
Bleeder Valve
- 10 Nm
- 4 -
Dust Cap
- Push onto bleed valve.
- 5 -
Seal
- Removing and installing, refer to REAR BRAKE CALIPER PISTON .
- 6 -
Pressure Nut
- To operate parking brake.
- 7 -
Pistons
- Removing and Installing, refer to REAR BRAKE CALIPER PISTON .
- 8 -
Guide Pins
- Grease before pulling on protective cap.
- Delivered as a replacement part with sufficient grease.
- Replacing, refer to REAR BRAKES GUIDE PINS AND PROTECTIVE CAPS .
- 9 -
Cap
- Pull onto the brake carrier and guide pin.
- Replacing, refer to REAR BRAKES GUIDE PINS AND PROTECTIVE CAPS
- 10 -
Brake Carrier with Guide Pins and Cap
- Supplied as an assembled replacement part with sufficient grease on guide pins.
- If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate guide pins.
- 11 -
Cap
- Removing and Installing, refer to REAR BRAKE CALIPER PISTON .
- Pull onto the piston with the outer sealing lip.