Brake Caliper, FBC
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2013 Audi S4, 2013 Audi A4, 2012 Audi S4, 2012 Audi A4, and 2011 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Install complete repair kit when servicing.
Apply thin coat of assembly paste G 052 150 A2 to brake cylinders, pistons and seals.
- 1 -
Bolt
- 30 Nm
- 2 -
Cap
- Insert in brake caliper.
- Replacing, refer to PROTECTIVE CAP AND GUIDE PINS, FBC BRAKES .
- 3 -
Guide Pins
- Slide through the boot.
- Replacing, refer to PROTECTIVE CAP AND GUIDE PINS, FBC BRAKES .
- 4 -
Cap
- Install on the bleeder valve.
- 5 -
Bleeder Valve
- Apply a thin coat of assembly paste G 052 150 A2 to the threads before screwing in.
- 15 Nm
- 6 -
Brake Caliper Housing
- 7 -
Spring
- Ensure installation position is correct.
- 8 -
Cap
- Do not damage when installing piston.
- coat with Assembly Paste G 052 150 A2
- 9 -
Pistons
- First apply thin coat of brake cylinder paste G 052 150 A2 on piston.
- Diameter 57 mm.
- 10 -
Seal
- Coat with assembly paste G 052 150 A2.
- 11 -
Brake Carrier
- Removing and Installing, refer to BRAKE CALIPER WITH FRONT BRAKE CARRIER, FBC-57 .
- The 4 retaining pins for the brake pads on the brake carrier must not be loosened under any circumstances.
- 12 -
Bolt
- 196 Nm