Flange Shaft Seals, Replacing, Rear Final Drive Removed: Removing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2015 Audi S4, 2015 Audi A4 Quattro, and 2014 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Follow all general repair information. Refer to GENERAL REPAIR INFORMATION .
-- Remove the rear final drive. Refer to REAR FINAL DRIVE, REMOVING AND INSTALLING, AUDI A4, A5 COUP E /SPORTBACK/CABRIOLET, A6, A7 .
-- Remove the flange shaft bolt. To do this, install two bolts into the flange and counterhold the flange shaft using an assembly lever.
-- Remove the flange shaft.
NOTE:
If it not possible to remove the flange shaft by hand, then use the Slide Hammer Set VW771 to remove it.
-- Remove flange shaft seal with the Slide Hammer Set VW771 and Slide Hammer Set - Hook VW771/37.