Overview - Wheel Set, Reverse Drive Gear, Gearshift Mechanism
WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission Housing
- With differential and pinion
- Input and Output Shafts with Shift Fork Group
- Disassembling and assembling. Refer to OVERVIEW - WHEEL SET .
- Oil Catch Tray
- Gets clipped in to the bearing bracket
- Reverse Drive Gear
- With the reverse shaft
- Reverse drive gear assembly overview; refer to Fig 2
- Oil Guide Element
- Magnet
- Clean off
1 - Reverse Drive Gear
Installation position: The shoulder faces the transmission housing.
2 - Needle Bearing
3 - Reverse shaft support
4 - O-Ring
5 - Reverse Shaft
Slide the O-ring onto the circular groove, -arrow- item 4.
The threaded hole on the reverse shaft must line up down the center with the opening on the reverse shaft support.