Noise Insulation, Removing And Installing: Installing
WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
-- Mount the noise insulation on the tabs -1- and then push down on it until the tabs -2- lock.
-- Stretch the boot over the shift lever into the rounded groove -arrow A-.
-- Press the support ring into the boot over the shift lever support in the direction of -arrow B- as far as the stop.
Install in reverse order of removal. Note the following:
-- Install the Multimedia System Control Head -E380-. Refer to Multimedia System Control Head -E380-, REMOVING AND INSTALLING .
-- Install the shift lever knob with the shift lever boot. Refer to GEARSHIFT KNOB, REMOVING AND INSTALLING .