Gear Recognition Sensor -G604-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2013 Audi S4, 2012 Audi S4, 2011 Audi S4, and 2010 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Replace the O-rings -4-.
CAUTION:
There is a risk of breaking or causing malfunctions in the Gear Recognition Sensor -G604- during installation.
- The Gear Recognition Sensor -G604- -3- may not be banged or bolted -1- into the transmission.
- The O-rings -4- and the opening in the transmission cover must be lubricated with transmission fluid.
- The Gear Recognition Sensor -G604- -3- may be lightly pressed on with an aid, for example a hammer shaft.
-- Secure the Gear Recognition Sensor -G604- with the bolt -1-. Tightening specification. Refer to Tightening Specification .
-- Connect the connector -1- and lock if necessary.
-- Tighten the bolts -arrows- on the tunnel crossmember. Tightening specification. Refer to OVERVIEW - SUBFRAME MOUNT -item 2- Bolt (See Figure).
-- Assemble the exhaust system making sure it is not under stress. Refer to OVERVIEW - MUFFLER , and EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .