3-Pin Relay/Fuse Carrier, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying 3 Pin Relay/Fuse Panel Components

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and remove the key.

-- Remove the driver side instrument panel cover. Refer to Storage Compartments and Covers .

-- Disengage the 3-pin relay/fuse carrier by pressing the retaining springs in the direction of the -arrow- and remove the relay/fuse carrier -1-.

-- Unclip the fuse panel on the relay/fuse carrier.

-- Remove the relay and control modules.

Fig 2: Identifying Retaining Clips

Courtesy of AUDI OF AMERICA, LLC

-- Release the retaining clips -arrows- and press the relay carrier -2- back and out of the bracket -1-.

NOTE:

The exact assignment of the 3-pin relay/fuse panel can be found in the applicable wiring diagram. Refer to appropriate SYSTEM WIRING DIAGRAM.