Servotronic Solenoid Valve -N119-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Servotronic Solenoid Valve Remove/Install Components

Courtesy of AUDI OF AMERICA, LLC

Installation is the reverse of removal, with special attention to the following:

-- Install a new screen -7-.

-- Lightly coat gasket -4- and -5- with Steering Gear Grease and insert.

-- Place the Solenoid Valve -- -3- into the power steering gear -6- as far as the stop. Do not tilt the Solenoid Valve -- when doing so.

CAUTION:

Always follow screw tightening sequence.

-- Tighten screws -1- and -2- as follows:

Tighten the bolt -1- to 0.5 Nm.
Tighten the bolt -2- to 1.5 Nm.
Tighten the bolt -1- to 3.0 Nm.
Tighten the bolt -2- to 3.0 Nm.

-- Steering gear, installing. Refer to HYDRAULIC POWER STEERING GEAR, REMOVING AND INSTALLING .