Overview - Power Steering Pump, Vehicles With 6-Cylinder Diesel Engine, Vehicles With Dynamic Steering
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Power Steering Pump, Removing and Installing, 6-Cylinder Diesel Engine, Vehicles without Dynamic Steering. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 6-CYLINDER DIESEL ENGINE, VEHICLES WITH DYNAMIC STEERING .
Power Steering Pump Assembly Overview
NOTE:
Always replace seals.
Do not reuse fluid you have drained.
Only use Hydraulic Fluid.
Fig 1: Overview Of Power Steering Pump, Vehicles With 6-Cylinder Diesel Engine (Vehicles With Dynamic Steering)
- Bracket
- Sleeve
- Drive the sleeve back slightly to install the power steering pump.
- Bolt
- 25 Nm
- Bolt
- Tightening specification. .
- Intake Hose
- The "P" marking on the evacuation hose -arrow- must align with the formed seam -arrow- on the power steering pump.
- Clamp
- Tension using Hose Clip Pliers VAG1275A
- Always replace if removed
- Union Nut
- 38 Nm
- Seal
- Always replace if removed
- Pressure LineCAUTION:
- Insert the pressure line completely when installing.
- Note the installation position: the angle between the line connection and the power steering pump axle must be approximately 88°.
- depending on the version, also mounted to the A/C compressor
- Bolt
- 25 Nm
- Belt Pulley
- Different versions: with and without a hole for counter-holding with a Wrench - Pin Type 3212
- Depending on the version, use either a Wrench - Pin Type 3212 or Counterhold - Kit - Multiple Use T10172 with Counterhold - Kit - Adapter 5 T10172/5.
- Power Steering Pump
- Allocate correct version.
- Fill with Hydraulic Fluid before installing
- Delivery pressure, checking. Refer to POWER STEERING PUMP, CHECKING DELIVERY PRESSURE, 6-CYLINDER DIESEL ENGINE, VEHICLES WITH AND WITHOUT DYNAMIC STEERING .
- Removing and installing. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 6-CYLINDER DIESEL ENGINE, VEHICLES WITH DYNAMIC STEERING .
- Bleed the steering. Refer to STEERING, BLEEDING AFTER REPLACING .
- Check hydraulic fluid level. Refer to POWER STEERING FLUID LEVEL, CHECKING .
- Steering System, checking for leaks. Refer to STEERING, CHECKING FOR LEAKS .
- Bolt
- 25 Nm