LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Steering (Sedan)) >> 48 Steering >> Power Steering Hydraulics >> Overview - Power Steering Pump >> Overview - Power Steering Pump, Vehicles With 4-Cylinder Diesel Engine, Vehicles With Dynamic Steering

Overview - Power Steering Pump, Vehicles With 4-Cylinder Diesel Engine, Vehicles With Dynamic Steering

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Power Steering Pump, Removing and Installing, 4-Cylinder Diesel Engine, Vehicles with Dynamic Steering. Refer to POWER STEERING PUMP, REMOVING AND INSTALLING, 4-CYLINDER DIESEL ENGINE, VEHICLES WITH DYNAMIC STEERING .

Power Steering Pump, with Dynamic Steering, Assembly Overview

NOTE:

Always replace seals.

Do not reuse fluid you have drained.

Only use Hydraulic Fluid.

Fig 1: Overview - Power Steering Pump, Vehicles With 4-Cylinder Diesel Engine (Vehicles With Dynamic Steering)
GWWA48-10450Courtesy of AUDI OF AMERICA, LLC
  1. Bracket
  2. Sleeve
    • Drive the sleeve back slightly to install the power steering pump.
  3. Bolt
    • 25 Nm
  4. Union Nut
    • 38 Nm
  5. Seal
    • Always replace if removed
  6. Pressure Line
    CAUTION:
    • Insert the pressure line completely when installing.
    • Note the installation position: the angle between the line connection and the power steering pump axle must be approximately 90°.
  7. Intake Hose
    • The "P" marking on the evacuation hose -arrow- must align with the formed seam -arrow- on the power steering pump.
  8. Clamp
    • Tension using Hose Clip Pliers VAG1275A
    • Always replace if removed
  9. Bolt
    • 22 Nm
  10. Belt Pulley
  11. Power Steering Pump
  12. Bolt
    • 25 Nm