Wheel Bearing Unit, Front Wheel Drive (Fwd), Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Puller - Grease Cap VW637/2
- Seal Installer - Camshaft Installer Kit - Sleeve 3241/4
- Torque Wrench 1332 40-200Nm VAG1332
- Torque Wrench 1410 VAG1410
- Grease
NOTE:
For a short period of time, wheel bearing housings for All Wheel Drive (AWD) vehicles were installed on Front Wheel Drive (FWD) vehicles, refer to -item 24 - Wheel Bearing Housing. A mixed installation is not permitted. Procedure for vehicles equipped with All Wheel Drive (AWD) wheel bearing housing. Refer to WHEEL BEARING UNIT, ALL WHEEL DRIVE (AWD), REMOVING AND INSTALLING and WHEEL BEARING UNIT, SERVICING .
For a short period, steel wheel bearing housings instead of aluminum wheel bearing housings were installed on Front Wheel Drive (FWD) vehicles. Do not install both types together.