Brake Booster Pressure Sensor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .
NOTE:
The Brake Booster Pressure Sensor -G294- is located in the plenum chamber near the brake booster.
-- Disconnect the connector -1-.
-- Remove the pressure sensor in the direction of the -arrow-.
NOTE:
The pressure sensor is secured with clips.
-- Release the clips with pliers -1-.
-- Carefully pry off the Brake Booster Pressure Sensor -G294-.