Oil pump, removing and installing
WARNING: This page is about a different car, the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Remove lower section of oil pan → Lower part of oil pan, removing and installing .
- Remove bolts - arrows -.
- Pull oil pump forward and off from drive shaft.
Installing
Installation is in reverse order of removal, note the following:
NOTE:
- Replace O-rings.
- Install oil pump onto drive shaft and fasten.
- Install lower section of oil pan → Lower part of oil pan, removing and installing .
- Add engine oil and check oil level → Oil level, checking .
Torque specifications
| Component | Nm |
|---|---|
| Oil pump to upper part of oil pan | 20 |