Engine, securing to assembly stand

WARNING: This page is about a different car, the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Special Tools - Engine, Securing To Assembly Stand

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Special tools, testers and auxiliary items required

Lifting tackle 2024 A
Engine and transmission holder VAS 6095 with bracket VAS 6095/1-5
Shop crane VAS 6100
Lift arm extension for workshop crane VAS 6101

Work procedure

Engine separated from transmission.

Fig 2: Hooking Engine Sling 2024 A Onto Engine And Onto Workshop Crane VAS 6100 With Lift Arm Extension For Workshop Crane VAS 6101

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Hook engine sling 2024 A onto engine and onto workshop crane VAS 6100 with lift arm extension for workshop crane VAS 6101 as shown in the illustration.

NOTE:

To be aligned to the center of gravity of the engine assembly, the hole rails of the lifting hook must be inserted as shown in the illustration.

CAUTION: Lifting hooks and alignment pins on the engine sling must be secured with securing pins - arrows -.

Fig 3: Removing Bolts And Left/Right Engine Support

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical harness connector - 1 - at left engine mount.
Remove bolts - arrows - and remove left engine mount.

Fig 4: Securing Engine On Engine And Transmission Holder VAS 6095 With Bracket For V6 FSI Engine VAS 6095/1-5

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Secure engine on Engine and Transmission Holder VAS 6095 with bracket for V6 FSI engine VAS 6095/1-5 as shown in illustration.