Windshield Washer Pump, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Windshield Washer Pump

Courtesy of AUDI OF AMERICA, LLC

-- Turn off the ignition and remove the key.

-- Remove left front wheel.

-- Remove the left front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Disconnect the connector -4-.

-- Place a drip tray under the windshield washer fluid reservoir.

-- Release the securing clip -2- in the direction of the -arrow- and remove the washer fluid line -1- from the windshield washer system washer fluid pump.

-- Remove the Windshield Washer Pump -V5- -item 3- upward out of the washer fluid reservoir.

NOTE:

Replace the Windshield Washer Pump -V5- bracket if it is damaged.

Fig 2: Removing Windshield Washer Pump Bracket

Courtesy of AUDI OF AMERICA, LLC

Press the damaged bracket -1- out of the mount in the washer fluid reservoir -2- toward the outside of the vehicle -arrow- using a screwdriver.