High Pressure Sensor G65, removing and installing
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Remove front bumper →
- 50 BODY, FRONT
- 50 - BODY - FRONT for BODY EXTERIOR - CABRIOLET
- Disconnect connector - B -.
- Remove High Pressure Sensor G65 - C -, tightening torque: 5 Nm.
- Replace O-ring - A - (10.8 mm; 1.8 mm) → O-ring seals for refrigerant circuit .
NOTE:
- The cooling output cannot be checked with the High Pressure Sensor G65 removed; the operating and display module, Climatronic Control Module J255 does not switch on the compressor.
- The refrigerant circuit remains closed, "connection with valve".
- Checking operation of High Pressure Sensor G65 and signal supplied and.