Refrigerant lines on evaporator flange, removing and installing: Installing
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order, paying attention to the following:
- Replace O-rings - B - and - C - ;
- Install refrigerant lines such that they are not strained.
- After installing refrigerant lines, check proper installation of grommet - E - and bushing - F -.
- Check position of refrigerant lines to evaporator. They must not make contact with other components.
- Check type of seal at connections and refrigerant lines (must be designed for same type of seal) → Connections of refrigerant lines to the components (different versions)
- Evacuate and recharge refrigerant circuit. → 87 - AIR CONDITIONING