Windshield - assembly overview: Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Windshield
- Removing → Windshield, removing .
- Installing → Preparing for window installation .
- Align distance - d - at sides.
NOTE:
- Stickers on windshield (e.g. for airbag) must be replaced in same position on new windshield.
2 - Upper spacer buffer
- Qty. 3, self-adhesive.
- Attach in regular intervals to retaining strip.
- Attach 1 in center of vehicle on window flange at a distance of 430 mm to left and right.
3 - Adhesive sealing material
- Observe curing times → Minimum curing times .
- Note varying spacing dimensions to window edge.
- Distances from upper and side window edge, dimension - a - = 16 mm and dimension - b - = 12 mm.
- The distance on the lower window edge is measured from the outer side of the clip outward.
- The distance to the lower window edge does not run in parallel distance to window edge.
- Distances Windshield, installing .
- Bead cross section.
- Bead width = 8 mm + +2 mm.
- Bead height = 13.5 mm + +1.5 mm.
4 - Lower spacer buffer
- Qty. 2, self-adhesive.
- Attach in corners on lower window edge.
5 - Window adjuster
- Slide sideways on lower window edge as far as stop.
6 - Plenum chamber cover
- Pull protective piping from retaining strip before installing plenum chamber cover Removing protective piping for grip channel .
- Press into fastening strip only after window adhesive curing time has elapsed.