ATF breather pipe, removing and installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Transmission removed.
- Remove bolt - B -.
- Pull ATF breather pipe - A - out of mount.
NOTE:
- If ATF leak is determined from check hole behind ATF breather pipe - A - , slightly below bolt - B - , transmission is malfunctioning and must be replaced.
Installing
Installation is in reverse order of removal, note the following:
- Insert new ATF breather pipe - A - until it reaches stop.
- Tighten ATF breather pipe with strap and bolt - B - on transmission housing.
Torque specification
| Component | Nm |
|---|---|
| ATF breather pipe to transmission housing | 25 |