Transmission Vehicle Speed Sensor (VSS) G38/Transmission Output Speed (RPM) Sensor G195 , removing and installing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Drain ATF → 37 - AUTOMATIC TRANSMISSION - CONTROLS, HOUSING .
Remove ATF oil pan → 38 - AUTOMATIC TRANSMISSION - GEARS, HYDRAULIC CONTROLS .

Fig 1: Transmission Vehicle Speed Sensor -G38- Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector - arrow - at Transmission Vehicle Speed Sensor (VSS) G38/Transmission Output Speed (RPM) Sensor G195.

Fig 2: Identifying Transmission Vehicle Speed Sensor (VSS) And Spacer

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolt and remove Transmission Vehicle Speed Sensor (VSS) G38/Transmission Output Speed (RPM) Sensor G195 - 2 - with spacer sleeve - 1 -.

Installing

Installation in reverse order of removal, note the following:

Position Transmission Vehicle Speed Sensor (VSS) G38/Transmission Output Speed (RPM) Sensor G195 - 2 - with spacer sleeve - 1 - on transmission and tighten bolt.

Spacer sleeve height: 8 mm.

Install ATF oil pan → 38 - AUTOMATIC TRANSMISSION - GEARS, HYDRAULIC CONTROLS .
Fill ATF → 37 - AUTOMATIC TRANSMISSION - CONTROLS, HOUSING .

Torque specification

Component	Nm
Transmission Vehicle Speed Sensor (VSS) G38/Transmission Output Speed (RPM) Sensor G195	6