Stator shaft, removing and installing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

ATF pump removed from ATF supply housing → ATF pump and ATF supply housing, removing and installing .

Fig 1: ATF Supply Housing Fasteners

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolts - arrows -.

Fig 2: Press Stator Shaft Under Shop Press With A Suitable Drift

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Warm ATF supply housing area around stator shaft to approx. 70° C with a hot air gun.
Press stator shaft under shop press with a suitable drift - 1 -.

Installing

CAUTION: Check ATF supply components for wear and damage → ATF supply .

Fig 3: Install Guide Pin M6 T10288/4 And Position Stator Shaft

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install guide pin M6 T10288/4 and position stator shaft.
Warm ATF supply housing area around stator shaft to approx. 70° C with a hot air gun.
Press stator shaft in under shop press using a suitable drift.

Fig 4: ATF Supply Housing Fasteners

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tighten bolts - arrows -.

Tightening torque: 10 Nm.