Sealing ring - as of serial number 42987 - with additional dust lip, installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Installation position: Open side of sealing ring faces towards torsen housing.
- Lightly oil new sealing ring on outer circumference.
- Drive on new flange shaft sealing ring to stop, when doing so, do not tilt.
- Fill area between sealing lip and dust lip halfway with sealing grease G 052 128 A1 .