Pressing in flange shaft

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressing In Flange Shaft

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Before pressing in flange shaft, tighten vibration damper (if installed).
Support flange shaft with thrust piece 2050.
Install circlip onto flange shaft Installation position of circlips - A - and - B -