Removing and installing circlip of synchro-hub and washer of 1st sliding gear

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing And Installing Circlip For Synchronizer Hub And Shim For 1st Gear Selector Gear

Courtesy of VOLKSWAGEN UNITED STATES, INC.

To remove circlip, remove washer -A- and then circlip -B-.
To install circlip, install on circlip -B- and then washer -A-.