Transmission oil level, checking
WARNING: This page is about a different car, the 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and other items required
- 3357 Allen key extension
- V.A.G 1331 Torque wrench
NOTE:
- The vehicle must be level for checking the oil level. An inspection pit or 4-pillar lifting platform are the most suitable methods.
- The oil filler plug is situated on the left of the transmission below the speedometer vehicle speed sensor and may be concealed by the heat shield for the drive axle.
- Use special tool 3357 to loosen oil drain plug.
- Remove oil filler plug to check gear oil level (arrow).
- Specification: Oil level up to lower edge of filler hole
- Top up gear oil if necessary. Specification. Refer to Code letters, assignment of mechanical units, transmission ratios and capacities onward.
- Install oil filler plug.
Tightening torque
| Component | Nm |
| Oil filler plug | 25 |