Right Engine Mount: Removing

Fig 1: Mounting 10 - 222 A With T40093/6 On Left And Right Suspension Strut Towers

Courtesy of AUDI OF AMERICA, LLC

-- Install the 10 - 222 A with one on the left and right strut towers, as shown in the illustration.

-- Attach the 10 - 222 A /11 to the left and right engine lifting eyes.

-- Lightly tension the engine with spindles.

-- Remove the right front wheel. Refer to WHEELS AND TIRES .

Fig 2: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Remove the right front wheel housing liner. Refer to WHEEL HOUSING LINER .

-- Remove the noise insulation -1 and 2-. Refer to NOISE INSULATION .

-- Remove and disconnect the connector -2- on the right electrohydraulic engine mount solenoid valve -N145-.

Fig 3: Loosening Nut On Electrical Wiring Bracket Several Turns

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nut -1- and remove the bracket with the wiring harness from the subframe.

-- Remove the bolts -1, 2 and 4- and move the right engine mount retaining plate -3- to the side.

Fig 4: Identifying Bolts And Right Engine Mount Retaining Plate

Courtesy of AUDI OF AMERICA, LLC

Vehicles with S-Tronic transmission 0B5 

Fig 5: Identifying ATF Line Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolt -arrow- on ATF line bracket.

All Vehicles 

Fig 6: Identifying Special Tool -- 10 - 222 A /11

Courtesy of AUDI OF AMERICA, LLC

-- Lift the engine by the right 10 - 222 A /11 -1- by dimension -a-.

• Dimension -a- = approximately 20 mm.

-- Remove the right engine mount.