Reduced Oil Pressure Switch -F378-: Removing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Engine Cover -1- And -2-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rear engine cover -2- upward.

-- Remove the noise insulation.

Fig 2: Identifying Reduced Oil Pressure Switch -F378-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the electrical connector -2- using the T10118.

-- Remove the reduced oil pressure switch -1- with a T40175.

NOTE:

The installation location is shown with the compressor removed.