Front Charge Air Cooling Circuit Radiator: Removing
-- Remove the lock carrier cover -4-. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
-- Remove the bolts -arrows-.
-- Remove the air duct -1- from the air filter housing intermediate flange -2-.
-- Remove the bumper cover end plate. Refer to OVERVIEW - BUMPER COVER .
-- Remove the left and right air intake grille -1-. Refer to AIR INTAKE GRILLE, REMOVING AND INSTALLING .
The bumper is not shown in the following illustrations.
-- Release the retaining tabs -A arrows- and tilt the left and right air ducts -1- toward the center of the vehicle -arrow B-.
-- Place the VAS 6208 under the front charge air cooling circuit radiator.
Vehicles with Version 2 Front Charge Air Cooling Circuit Radiator
-- Disconnect and remove the coolant hoses and 3094, to do this, loosen the hose clamps -arrows-.
Vehicles with Version 1 Front Charge Air Cooling Circuit Radiator
-- Disconnect and remove the coolant hose and 3094, to do this, loosen the hose clamps -arrows-.
-- Remove the bolt -1-.
-- Open the clamp -1-. Then remove both the coolant hose and the 3094
All Vehicles
-- Press the catch downward -arrow A- and move the front charge air cooling circuit radiator in direction of -arrow B-.
-- Remove the front charge air cooling circuit radiator from the radiator -arrows A- and move it in direction of -arrow B-.
-- Remove the front charge air cooling circuit radiator downward from the right side -arrow C-.