LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (3.0L - Cooling System - Engine Code(S): CCBA (Cabriolet)) >> 19 Cooling System >> Description And Operation >> Coolant Hose Connection Diagram

Coolant Hose Connection Diagram

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Risk of scalding due to hot steam and hot coolant.

  • The coolant system is under pressure when the engine is warm.
  • Cover the coolant reservoir cap with a cloth and then open it slowly to release the pressure.

Danger of personal injury due to the coolant fan turning on by itself.

  • Disconnect the connectors before working near the fan shroud.
NOTE:

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

The arrows on the coolant pipes and ends of coolant hoses must align.

NOTE:

Blue = large coolant circuit.

Red = small coolant circuit.

Orange = coolant circuit for the charge air cooler.

Brown = heating circuit.

The arrows show the coolant flow direction.

Vehicles without Auxiliary Heater 

Fig 1: Identifying Vehicles Without Auxiliary Heater
GWWA19-10867Courtesy of AUDI OF AMERICA, LLC
  1. Front Charge Air Cooling Circuit Radiator
    • Change coolant after replacing
  2. Radiator
    • Vehicles with dual clutch transmission: With integrated ATF cooler
    • Change coolant after replacing
  3. Coolant Temperature Sensor -G62-
  4. Coolant Thermostat
  5. Coolant pump
  6. Charge Air Cooler on the Right Side
    • inside the compressor housing
    • change coolant after replacing
  7. Coolant Switch-Off Valve
  8. Bleeder Screw
  9. Cylinder Head Bank 1 (right)
    • change coolant after replacing
  10. Heat Exchanger for Heater Unit
    • Removing and installing, refer to the appropriate Service Information
    • change coolant after replacing
  11. Bleeder Hole
  12. Cylinder Head Bank 2 (left)
    • change coolant after replacing
  13. Bleeder Screw
  14. Left Charge Air Cooler
    • Inside the compressor housing
    • Change coolant after replacing
  15. Coolant Reservoir Cap
  16. Coolant Reservoir
  17. Engine Oil Cooler
  18. After-Run Coolant Pump -V51-
    • Depending on country
  19. Non-Return Valve
    • In the coolant hose
  20. Charge Air Coolant Pump -V188-
  21. Left Charge Air Cooling Circuit Radiator
    • change coolant after replacing
  22. Non-Return Valve
    • In the coolant hose
  23. Non-Return Valve
    • In the coolant hose