Center Differential Housing: Notes
WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Thrust Plate VW 401
- Thrust Plate VW 402
- Thrust Disc VW 412
- Tube 60 mm Dia. VW 415 A
- Press Tube 30 - 100
- Press Tube 2040
- Thrust Piece T40165
- Thread Locking Compound AMV 185 101 A1
- Sealing Grease G 052 128 A1
- Center Differential
- Service by manufacturer only
- Spring
- Adjustment Shim
- Plate Spring
- Installed position: the camber on the inner diameter faces toward the flange shaft
- Spacer Sleeve
- Securing Ring
- For flange shaft
- Removing and installing, refer to REMOVE THE CIRCLIP -ARROW-.
- Ball Bearing
- For flange shaft
- Removing INSTALLING THE FLANGE SHAFT BALL BEARING AND SPACER SLEEVE
- Installing REMOVING THE FLANGE SHAFT BALL BEARING AND SPACER SLEEVE
- Shaft Seal
- Prying out PRYING OUT THE SHAFT SEAL -1-
- Installing INSTALLING THE SEAL FOR THE REAR FLANGE SHAFT
- Rear Flange Shaft
- Without vibration damper
- Allocate components shims.
- Removing PRESSING OUT FLANGE SHAFT
- Installing PRESSING IN FLANGE SHAFT
- Rear Flange Shaft
- With vibration damper
- Allocate components shims.
- Removing PRESSING OUT FLANGE SHAFT
- Installing PRESSING IN FLANGE SHAFT
- Bolt
- 15 Nm plus an additional 90° turn
- For vibration damper
- Quantity: 3
- Insert with locking fluid AMV 185 101 A1
- Vibration Damper
- Not present on all versions
- Allocate according to transmission code.
- Center Differential Housing
- Removing and installing with transmission installed, refer to Removal and Installation