Drive Plate: Removing
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is removed. Refer to REMOVAL AND INSTALLATION or Removal and Installation .
-- Insert the 10 - 201 to loosen the bolts.
CAUTION:
The outer surface of the bearing flange at the drive plate could be damaged.
- Use a multipoint socket wrench with a shaft at least 40 mm long to loosen and tighten the drive plate bolts.
-- Remove the bolts, drive plate and sensor wheel.