Clutch Release Lever With Release Bearing And Guide Sleeve: Installing
WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
-- Clean the guide sleeve -6- and install with the locking plate -5-.
-- Clean boot threads -4- with a wire brush. Then install and tighten the bolts with locking fluid AMV 185 101 A1. Tightening specification, refer to item 6.
CAUTION:
Noises when actuating the clutch
- Lubricate the bearing area on the clutch release lever with adhesive lubricating paste G 000 150. Refer to item 5.
-- Engage the release bearing -2- and the spring -3- into the clutch release lever -1- and install them both.