Release Bearing With Pressure Ring -1- From February 2008
WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- The pressure ring for the release bearing -1- may have axial and radial play.
- The pressure ring -1- can tip on all sides inside the release bearing -3-.
- If the running surface -arrow 2- on pressure ring -1- is worn deeper than 0.8 mm, the release bearing -3- must be replaced.
- The pressure ring is almost loose when the release bearing is not touching the clutch.