Transmission Range Gear Recognition Switch -F208-: Installing

WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Install the transmission range gear recognition switch -- in the selector shaft cover. Tightening specification TRANSMISSION RANGE GEAR RECOGNITION SWITCH -F208- .

Fig 1: Installing Connector On Transmission Range Gear Recognition Switch

Courtesy of AUDI OF AMERICA, LLC

-- Install the connector -2- on the transmission range gear recognition switch --.

NOTE:

Disregard -1 and 3-.

-- Install the tunnel crossmember -arrows- -2- 2.

Fig 2: Identifying Bolts & Tunnel Crossmember

Courtesy of AUDI OF AMERICA, LLC

-- Re-assemble the exhaust system and ensure it is not under stress. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .

-- Install the noise insulation. Refer to NOISE INSULATION .

Tightening Specification

Component	Nm
Transmission range gear recognition switch -F208-	20