Gear Recognition Sensor: Installing
WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Replace the O-rings -4-.
CAUTION:
There is a risk of breaking or causing malfunctions in the gear recognition sensor -- during installation.
- The gear recognition sensor -- -3- may not be stamped on or imbedded with a bolt -1- into the transmission.
- The O-rings -4- and the opening in the transmission cover must be lubricated with transmission fluid.
- The gear recognition sensor -- -3- may be pressed lightly on using an aid for example the shaft of a hammer.
-- Secure the gear recognition sensor -- with the bolt -1-. Tightening specification GEAR RECOGNITION SENSOR
-- Connect the connector -2-.
-- Install the tunnel crossmember -arrows-, tightening specifications -2- 2.
-- Re-assemble the exhaust system and ensure it is not under stress. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .
-- Install the noise insulation NOISE INSULATION .
Tightening Specification
| Component | Nm |
|---|---|
| Transmission range gear recognition switch -F208- | 10 Nm +45° |