ATF Pipes: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
Tightening specifications:
NOTE:
Replace the O-rings.
CAUTION:
There is a risk of damaging the transmission.
- When disassembling, remove all the plugs, which were taken from the VAS 6122 from the ATF pipes and from the transmission.
- The ATF cooling function will not work and the transmission will be damaged if the plugs are forgotten.
-- First insert the ATF pipes into the transmission and radiator by hand as far as the stop and then bolt them on.
-- Check the ATF level after installing the transmission. Refer to ATF, CHECKING LEVEL AND CORRECTING .