3. Check The Closing Locks - Vehicles With Keyless Stop And Start Systems

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Press the access/start authorization button -E408- briefly to get "ignition on".

-- Do not move the selector lever into "P" but rather, for example, into "N".

-- Turn off the ignition.

A warning message must appear in the instrument cluster.
The vehicle cannot be locked.

-- Turn on the ignition, shift the selector lever into the "P" position.

-- Turn off the ignition.

The vehicle can be locked.

If the specified values are not obtained:

-- Perform Guided Fault Finding using the vehicle diagnostic tester.

-- Adjust the selector lever cable. Refer to SELECTOR LEVER CABLE, ADJUSTING .

-- Locking button on selector lever handle, checking SELECTOR MECHANISM, CHECKING .