Right Flange Shaft: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Flange Shaft Clamped In Vise And Using New Circlip To Press Old Circlip Out Of Groove In Flange Shaft
Install in reverse order of removal. Note the following:
NOTE:
Replace the circlip on the right flange shaft.
-- Clamp the flange shaft in a vise with jaw protectors. Remove the old circlip from the groove in the flange shaft using the new circlip -A-.
-- Fill the space between the sealing- and dust lip half way with sealing grease;
-- Drive the right flange shaft in using the VW 295.
-- Fill with Manual Transmission Fluid (MTF), refer to General Information .