Continuation For A Removed Or Installed Transmission

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Place the V.A.G 1782 under the transmission.

Fig 1: Tightening Specification And Sequence, Center Differential Housing - Attached Driveshaft

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 through 4- and carefully remove the center differential housing. The Manual Transmission Fluid (MTF) will leak out while doing this.

Fig 2: Center Differential

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Danger of damaging the center differential.

Carefully and slowly pull center differential housing off of transmission toward rear. Otherwise the center differential can fall out of the transmission.
A center differential that has fallen out may not be installed.

-- Remove the guide sleeve -4- and pressure spring -3-.

-- Pull the center differential -2- toward the rear.

If the gear carrier -1- remains in the center differential housing, proceed as follows:

Fig 3: Holding Gear Carrier -1- By One Of Side Ribs With Pliers And Remove It In Direction Of -Arrow A-

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Danger of damaging the sealing surface on the center differential housing.

Use a hammer to hit the housing carefully on several places.

NOTE:

In this case the center differential is pulled off together with the center differential housing.

-- Hold the gear carrier -1- by one of the side ribs with pliers and remove it in -arrow A-.

-- Using a rubber hammer, tap the housing on alternating sides -arrows B-.