Removing The Bearing Inner Race From The Hub: Notes

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Bearing Inner Race And Spinning Washer

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the separating tool between the bearing inner race -1- and the wheel hub -2- and pretension with the spindle.

NOTE:

Use a commercially available separating tool, such as the Kukko 15/3 with 17/3.

-- Use the special tools as shown in the figure.

Fig 2: Identifying Tool Set Up

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Press Piece - Multiple Use:VW412
Hydraulic Press - Bushing Assembly Tool Kit - Sleeve:T10230/8
Hydraulic Press - Bushing Assembly Tool Kit - Thrust Piece:T10230/3
Wheel hub
Bearing inner race
Kukko 15/3 with 17/3

-- Press the bearing inner race from the hub.