LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 1325 (Wheels, Tires, Wheel Alignment (Wheel And Tire Guide General Information)) >> 44 Wheels, Tires, Wheel Alignment >> Tires, Mounting >> Tires And Rims, Matching

Tires And Rims, Matching

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- If necessary repair flat spots from standing. Refer to FLAT SPOTS, CORRECTING .

-- Dismount the tire. Refer to TIRES, DISMOUNTING .

-- Turn the tire about 180° against the rim.

-- Inflate the tire to 4 bar (58.01 psi).

-- Tension the wheel with the tire on the balancing machine.

-- Check the tire and wheel radial and lateral run-out. Refer to WHEELS AND TIRES, RADIAL AND LATERAL RUN OUT, CHECKING WITH TIRE DIAL GAUGE .

-- If the radial and lateral run-out are within the specified values, balance the wheel to 0. Refer to TIRE AND WHEEL RADIAL AND LATERAL RUN-OUT, CHECKING, TOLERANCES .

-- If the radial and lateral run-out are outside the specified values, match the tire and rim again and rotate the tire 90° relative to the rim.

-- Check the tire and wheel radial and lateral run-out again. Refer to WHEELS AND TIRES, RADIAL AND LATERAL RUN OUT, CHECKING WITH TIRE DIAL GAUGE .

-- If the radial and lateral run-out are within the specified values, balance the wheel to 0. Refer to TIRE AND WHEEL RADIAL AND LATERAL RUN-OUT, CHECKING, TOLERANCES .

-- If the radial and lateral run-out are outside the specified values, match the tire and rim again and rotate the tire 180° relative to the rim.

-- Check the tire and wheel radial and lateral run-out again. Refer to WHEELS AND TIRES, RADIAL AND LATERAL RUN OUT, CHECKING WITH TIRE DIAL GAUGE .

-- If the radial and lateral run-out are within the specified values, balance the wheel to 0. Refer to TIRE AND WHEEL RADIAL AND LATERAL RUN-OUT, CHECKING, TOLERANCES .

-- If the radial and lateral run-out are still outside the specified values check the rim for radial and lateral run-out. Refer to RIM RADIAL AND LATERAL RUN-OUT, CHECKING .

-- In the radial and lateral run-out of the rim is within the specified values, replace the tire.

scientia non olet · About LEMON Manuals