LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2014 >> A5 Prestige >> Repair and Diagnosis >> External Pages >> Different car >> Section 1325 (Wheels, Tires, Wheel Alignment (Wheel And Tire Guide General Information)) >> 44 Wheels, Tires, Wheel Alignment >> Rim Information >> Valve, Removing And Installing >> Valve, Removing And Installing, Metal Valve >> Installing

Valve, Removing And Installing, Metal Valve: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

Only apply the specified torque to tighten the nut for the metal valve.

Tightening more is not permitted because it damages the seal.

-- Tighten the nut -1- of the metal valve.

GWWN44-10443Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.

-- Install the Tire Pressure Monitoring Sensor --. Refer to TIRE PRESSURE MONITORING SENSOR, REMOVING AND INSTALLING, WITHOUT VALVE, VERSION 1, SERVICE VERSION .

scientia non olet · About LEMON Manuals