Left/Right Rear Level Control System Sensor -G76- / -G77-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Bolt -1-, Harness Connector -2- & Screws -3-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Only sensors of the same version may be installed.

-- Adapt replacement part accordingly and install.

-- Install the bolts -3- using an angled wrench. Do not bend upper retaining plate when doing so.

NOTE:

Hold Level Control System Sensor Securely When Tightening Screws -3-.

Sensor Lever Must Point Outward.

-- Install the bolt -1-.

-- Re-establish the connector -2-.

Tightening Specifications. Refer to OVERVIEW - TRANSVERSE LINK .

-- Perform the basic setting of the headlamps. Refer to HEADLAMPS .

-- If the Level Control System Sensor -- was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the control position must be reprogrammed using the Vehicle Diagnostic Tester. Refer to CONTROL POSITION, PROGRAMMING .

-- If the control position was reprogrammed on vehicles with lane assist, the Directional Stabilization Assistance Control Module -J759- must be calibrated again. Refer to LANE ASSIST, CALIBRATING .