Central Valve, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
The central valves are attached to the impact member under the bumper cover in the rear and on the left side.
-- Remove the rear bumper cover. Refer to REAR BUMPER .
WARNING:
Always wear safety goggles!
NOTE:
The DRC lines must be extracted before disconnecting them from the central valve. Refer to DYNAMIC RIDE CONTROL (DRC), SYSTEM DRAINING AND FILLING .
Perform this step on both wiring harnesses on the central valve.
-- Remove the DRC lines -5 and 6- or -9 and 10- depending on the central valve.
-- Remove the bolts -13- and the central valve.